Miller concrete decking Fusion Roof steel Anchor Post for fall protection. Concrete expansion bolt anchor kit included.

Miller concrete decking Fusion Roof Anchor Post for fall protection. This anchorage is mainly made of stainless steel which allow it to support a weight of 310 lb (140 kg). This device requires a full-body harness and a shock-absorbing lanyard. The use of a self-retracting lanyard, a lifeline, fall limiter or a rope grab is optional and may depend on the workers need.

This roof anchor post comes with a concrete expansion bolt anchor kit.

Please allow 3 to 4 weeks for delivery.

Dimensions
Plate Width: 15 ¼ in (38.7 cm)
Plate Length: 22 in (55.9 cm)
Post Height: 8.6 in (21.8 cm)
Post Diameter: 4 in (10.2 cm)

According to Miller, this roof anchorage can resist a tensile strength of 5000 lb (22 kN) which meets the standard ANSI Z359.1-2007, but also OSHA 1910.66, OSHA 1926.502 and ANSI A10.32.

This roof anchor post is designed to be used as a single anchorage point for personal fall arrest system, but when otherwise indicated, it may also be used as a part of a horizontal lifeline. For more information, please consult the manufacturer’s manual.

A safe installation of this anchor requires a smooth surface made of concrete to allow a firm footing. Moreover, the concrete surface must be at least 6 ½ in (165 mm) thick and resist to a minimum compressive strength of 3000 Psi (20.7 MPa). The anchor must be positioned at least 3 ft. (0.9 m) away from edges. Please consult the manufacturer’s manual for more details.

Inspection:

The worker is responsible for visually inspecting his equipment before each use. During this routine inspection, the worker must note any signs of degradation, malfunction, or breakage. The anchor will have to be replaced if any such signs are detected.

On top of this routine inspection, the anchor must be inspected by a qualified person different than the worker. The frequency of these inspections varies according to the manufacturer. Some manufacturers require an inspection every 90 days, others every 180 days, or even yearly. These inspections should be performed more often if your equipment is used in extreme environmental working conditions.

Any equipment that has withstood a fall or an impact must be scrapped.

Suggestion:

To complete your fall protection you will find a range of harness, lanyards and self-retracting lanyards. Some products are suggested under the "accessories" tab at the bottom of this page.

Other equipment frequently used with this safety harness:

Safety glasses YA12E91001
Liberty TA14LR safety helmet and the essential TA14CS chin strap
EPTCONE28B Traffic Cones
Peakworks FPBAG storage bag
The FPL9901 Tool Strap

The texts coloured in green correspond to hyperlinks leading to specific safety equipment or to a general information link.