Miss Miller safety harness for women with 1 back D-ring and friction buckles class A

$309.00

Please select the available option below :

Miss Miller safety harness for women, CSA class A, with ne back D-ring and a dorsal comfort pad. The chest straps and leg straps close with mating buckles. This safety harness is specially designed for women: the straps are designed to transfer the impact of a fall arrest to the hips. Moreover, the pectoral strap is placed higher, so as to not put pressure on the chest, and the shoulder straps are placed farther apart around the chest.

Ideal for maintenance work, construction work, etc.

Complies with CSA standard Z259.10-06.

Miller product code : E570/URN.

This safety harness is equipped with one back D-ring made of steel. The base of this ring is padded, for added comfort for the worker. Moreover, it prevents straps from tangling.

This harness is available in 3 sizes:

    • extra small (XS);
    • small to medium (S-M);
    • large to extra-large (L-XL);

The item number of this model corresponds to the size L-XL. To find out which size fits you best, please consult the manufacturer's sizing chart (available as a PDF file linked at the end of this description).

This harness can support a maximum weight of 400 lbs (181.4 kg), including clothing, tools, etc.

This Miss Miller safety harness is made of woven polyester straps. These straps are specially designed to be stretchable, and the pectoral strap is designed to rest above the chest. This allows workers to feel less discomfort and resistance when moving about, which contributes to reduce the fatigue experienced. The chest straps and leg straps close with mating buckles.

The harness certification tags are protected by a label casing.

The worker is responsible for visually inspecting the harness before each use. During this routine inspection, the worker must note any signs of degradation, malfunction, or breakage. The harness will have to be replaced if any such signs are detected.

On top of this routine inspection, the harness must be inspected by a qualified person different than the worker that wears the harness. The frequency of these inspections varies according to the manufacturer. Some manufacturers require an inspection every 90 days, others every 180 days, or even yearly. These inspections should be performed more often if the harness is worn in extreme environmental working conditions.

The recommended lifetime of a safety harness if 5 years. While some manufacturers keep silent on this topic, in practice, if the harness is used regularly and stored and maintained in standard conditions, its lifetime will not exceed 5 years in most cases.

Sylprotec offers a safety harness inspection service. Find out more by clicking on the Services tab, under the Sylprotec logo at the top of the page.

Any equipment that has withstood a fall or an impact must be scrapped.

For cleaning, use a gentle soap or detergent and lukewarm water (37°C). Do not use bleach, chlorine, or other abrasive or chemical products. If your harness is too dirty or contaminated, it is time to replace it.

Air dry without using heat, in a clean environment. You can accelerate the drying process by wiping the wet harness with a clean absorbent wipe, or by using a fan. Avoid exposing the harness to sunlight and to any sources of contamination.

Reviews

No customer reviews for the moment.

Write a review
Miss Miller safety harness for women  with 1 back D-ring and friction buckles class A

Miss Miller safety harness for women with 1 back D-ring and friction buckles class A

16 other products in the same category: