Peakworks Peakpro class A, P, full body harness equipped with 3 D-Rings, Quick-Connect buckles

Peakworks Peakpro class A & P, full body fall arrest harness equipped with 1 stand-up back D-Ring and 2 positioning lateral D-Ring. Webbings on the chest and at the thighs feature quick-connect buckles for easy donning. This full body harness is ideal for general tasks at heights which require this type of equipment such as maintenance  or construction work.

Peakworks product code: V8006110 or model FBH-60110B.
Meets ANSI Z359.1 and CSA Z259.10-12 requirements.

This safety harness is equipped with one back D-ring made of steel. The base of this D-ring is padded for added comfort for the worker. Moreover, it prevents straps from tangling. Also includes trauma straps to allow the fallen worker to stand up while awaiting recovery and avoid losing consciousness.

This harness can support a weight of 400 lb (181.4 kg) including clothing, tools and equipment.

The Peakworks Peakpro safety harness is made with high visibility colored polyester webbing. In addition, they have distinct colors for easy donning. The straps are padded on the shoulders, back and legs to provide more comfort for workers. To improve safety, this harness is equipped with a sub-pelvic strap. Polyester straps offer better resistance to acidic chemicals.

The chest and thigh straps are joined by quick release buckles. This harness has 5 adjustment points: 2 on the legs, 2 on the torso and 1 on the chest. Product identification and certification labels are sewn onto the back straps on the left side of the safety harness. It includes a fall indicator for easy inspection.

Inspection:

The worker is responsible for visually inspecting the harness before each use. During this routine inspection, the worker must note any signs of degradation, malfunction, or breakage. The harness will have to be replaced if any such signs are detected.

On top of this routine inspection, the harness must be inspected by a qualified person different than the worker. The frequency of these inspections varies according to the manufacturer. Some manufacturers require an inspection every 90 days, others every 180 days, or even yearly. These inspections should be performed more often if the harness is worn in extreme environmental working conditions.

The recommended lifetime of a harness is 5 years. While some manufacturers keep silent on this topic, in practice, if the lanyard is used regularly and stored and maintained in standard conditions, its lifetime will not exceed 5 years in most cases.

Sylprotec offers a harness inspection service. Find out more by clicking on the Services tab, under the Sylprotec logo at the top of the page.

Any equipment that has withstood a fall or an impact must be scrapped.

Maintenance:

For cleaning, use a gentle soap or detergent and lukewarm water (37°C). Do not use bleach, chlorine or other abrasive or chemical products. If your harness is too dirty or contaminated, it is time to replace it. Air dry without using heat in a clean environment. You can accelerate the drying process by wiping the wet harness with a clean absorbent wipe, or by using a fan. Avoid exposure to sunlight and to any sources of contamination.

Suggestion:

To complete your fall protection you will find a range of lanyards, retractable and anchors. Some products are suggested under the "accessories" tab at the bottom of this page.

Other equipment frequently used with this safety harness:

Safety glasses YA12E93101DX
Liberty TA14LR safety helmet and the essential TA14CS chin strap
EPTCONE28 Traffic Cones
Peakworks FPBAG storage bag
The FPL9900 Tool Strap

The texts coloured in green correspond to hyperlinks leading to specific safety equipment or to a general information link.