FPLA9902

Slim tool attachment strap for harness 28 in (71 cm) long, 9/16 (1.43 cm) wide, capacity 15 lb (6.82Kg)

$28.00

Return conditions : No returnable if used. For more information about our return policy, please refer to the "Orders and Returns" link on the home page

Peakworks harness tool attachment strap with carabiners. These cords must be paired with retaining clamps to operate. Clamps are sold separately. See FPLAFPLAPFPLAB products.

Peakworks product code: V856230 or model TT-9902

  • Slim Line tool lanyard for smaller, lighter tools, 28 in (71 cm) 9/16 (1.43 cm) wide
  • Capacity of 15 lb (6.82 kg)
  • Durable for long-lasting use
  • Strap made of polyester

Maintenance:

For cleaning, use a gentle soap or detergent and lukewarm water (37°C). Do not use bleach, chlorine, or other abrasive or chemical products. If your strap is too dirty or contaminated, it is time to replace it. Air dry without using heat, in a clean environment. You can accelerate the drying process by wiping the wet harness with a clean absorbent wipe, or by using a fan. Avoid exposing the harness to sunlight and to any sources of contamination.

Suggestion:

To complete your fall protection you will find a range of lanyardsretractable and anchors. Some products are suggested under the "accessories" tab at the bottom of this page.

Other equipment frequently used with this safety equipment:

Clamp for round tools FPLA
Clamp for flat tools FPLAP
Retaining block for round tools FPLAB
Peakworks FPBAG storage bag
The FPH4000AP safety harness

The texts coloured in green correspond to hyperlinks leading to specific safety equipment or to a general information link.

Type of productSafety equipment
Main categoryPersonal protection
Sub categoryFall protection
Sub sub categoryFall protection safety harness
Name of the productTool attachment strap
Product codeFPL9902
Approved/CertifiedNone
ManufacturerPeakworks
Country of originChina
FormatLength 28" / 71 cm by 9/16" /1.43 cm wide
ReusableReusable with careful inspection and proper installation
FeaturesHarness tool strap with carabiners for lightweight tools
IncludesWith two carabiners
Property of the materialPolyester straps offer better resistance to acidic chemicals
Load capacityMaximum capacity of 15 lb / 6.82 Kg
Material1Polyester
Material2Steel
WashableWash in warm water, 98.60°F/ 37°C. Never use bleach or other abrasive or chemical products on your strap. Air dry
Length (in/cm)6 in / 15.24 cm
Width (in/cm)3 in / 7.6 cm
Height (in/cm)2 in / 5.08 cm
Weight (lb/kg)2 lb / 0.9 Kg
Sold byUnit
ColorHigh Visibility Green
Return conditionsNo returnable if used. For more information about our return policy, please refer to the "Orders and Returns" link on the home page
CautionThese cords must be paired with retaining clamps to operate, see FPLA, FPLAP, FPLAB products

Accessories

23 other products in the same category: