Yellow barricade tape, DANGER, 3 in X 1000 ft.

Yellow DANGER barricade tape for temporary marking

The ECT3YE7 barricade tape visually marks a hazardous area or an access point that needs to be limited. Its yellow and black colour and DANGER message draw attention for workers, visitors, delivery personnel or contractors approaching the marked perimeter. This polyethylene tape measures 3 in wide by 1000 ft long, with a 1.5 mil thickness. It supports visual organization on a site without replacing physical barriers, internal procedures, supervision or required protective equipment.

Features of ECT3YE7 yellow DANGER tape

This tape is made to create a simple, quick visual reminder around an area that needs to be identified. Its DANGER message suits situations where the site needs to reinforce caution before entry into an active or temporarily restricted zone.

• Product code: ECT3YE7.
• Material: polyethylene.
• Colour: yellow and black.
• Message: DANGER.
• Tape dimensions: 3 in x 1000 ft, equivalent to 7.6 cm x 305 m.
• Thickness: 1.5 mil.
• Package dimensions: 9 in x 9 in x 4 in.
• Package weight: 2.9 lb.

Applications for worksites, docks and maintenance

ECT3YE7 tape can be used to temporarily identify worksite limits, a maintenance perimeter, a hazardous dock area, a warehouse section, a repair area or an access point that must be limited. It helps make a temporary separation visible when people need to be warned before crossing into an area.

Installation and inspection of temporary marking

Before installation, identify the perimeter to mark, the travel paths to keep open and the other protective measures required. The tape should be placed on suitable supports so the message remains legible without creating an obstacle in authorized passages. Inspect the marking during use, replace damaged or unreadable sections and remove the tape when the temporary marking is no longer needed.

FAQ about yellow DANGER barricade tape

What message appears on ECT3YE7 tape?

This yellow and black model carries the DANGER message to visually warn people approaching a hazardous area or an access point that needs to be limited.

What are the tape dimensions?

The tape measures 3 in x 1000 ft, equivalent to 7.6 cm x 305 m. The indicated thickness is 1.5 mil.

What material is it made from?

The tape is made from polyethylene, a flexible material used for temporary marking tapes.

Can it replace a physical barrier?

No. It provides a visual warning, but it does not physically block passage. Necessary barriers, procedures and other safety measures must remain in place.

Where can this DANGER tape be used?

It can be used on worksites, in maintenance areas, on docks, in warehouses and near access points that need to be temporarily limited.

Suggestions to complete zone marking

To vary barricade tape messages, the red danger tape (ECT3RE9) offers a DANGER message on a red background, the yellow warning tape (ECT3YF1) shows ATTENTION, the yellow caution tape (ECT3YE1) uses the CAUTION message, and the bilingual tape (ECT3YB1) adds French and English wording for restricted access points.

To support the perimeter, the line with flags (EFLAC) offers a reusable 328 ft option, the post (EPAL191) provides a 47 in support, the loop model (EPAL192) offers a 44 in height, and the beacon (EPAL2319) gives a 48 in high visibility roadside post.

The texts coloured in green correspond to hyperlinks leading to specific safety equipment or to a general information link.