LED strip lights for emergency "Exit" light signs

Replacement LED strip lights for Baghelli Exit signs

The LED strip light (LCBD142) is the strip of light-emitting diodes designed to relight Baghelli brand emergency "Exit" sign units. When the original LEDs weaken or stop working, this strip is the part you replace to restore the sign's full brightness, without having to change the entire housing. It is a cost-effective maintenance part that extends the life of an already-installed fleet of signs while keeping the evacuation signage perfectly legible.

LED technology was chosen for its very low power draw and long service life: unlike conventional bulbs, an LED strip runs cool, withstands vibration and keeps a stable intensity for years. By replacing only the light strip rather than the whole sign, you reduce maintenance cost and waste while keeping the exit signage compliant.

Benefits of the LED strip light for Exit signs

Beyond a simple swap, this LED strip brings concrete benefits for building maintenance and compliance.

Energy savings and long LED service life

Light-emitting diodes use a fraction of the energy of a traditional bulb and last far longer, reducing how often replacements are needed and lowering the electricity cost of permanent signage.

Compatibility with Baghelli Exit units

This strip is designed as a replacement part for Baghelli Exit signs, ensuring a format and connection suited to the original unit for fast maintenance.

Worksites and sectors where this LED strip is required

Replacing an Exit sign light strip is required everywhere evacuation signage must stay fully functional:

• Commercial buildings, offices and apartment buildings fitted with Baghelli Exit signs.
• Institutional facilities (schools, hospitals, long-term care homes) where emergency lighting is regulated.
• Stores, restaurants and hotels that must keep their exits clearly marked.
• Industrial buildings and warehouses subject to emergency lighting system inspection.
• Any maintenance manager replacing end-of-life LEDs during a periodic test.

Installation and maintenance of the LED strip light

Replacement involves removing the old LED strip from the Exit unit and connecting the new strip to its original connector. Installation is not included and should be carried out by a qualified person according to the sign's wiring. After fitting, an emergency-mode test (the unit's test button) confirms the new strip lights up correctly, both on mains power and in battery mode.

FAQ about the LED strip light for Exit signs

Does this strip fit all Exit signs?

The LCBD142 strip is designed for Baghelli brand Exit units. For another manufacturer or model, check the format and connection before ordering.

Is installation included?

No, installation is not included. The strip is supplied as a replacement part to be fitted by a qualified person.

Do LEDs last longer than bulbs?

Yes. Light-emitting diodes offer a significantly longer service life and lower power consumption than traditional incandescent bulbs.

Suggested complementary emergency lighting equipment

Replacing an LED strip often goes with the full maintenance of an Exit sign fleet; to complete your installation, also see a harness for the LED strip (LCBD322R), a 17 in. multivoltage strip (LCB071433), an Exit sign with battery (LUMB), a replacement battery (LBLUM), a single 9 W spotlight (LUMT1), a 6 V 36 W unit (LU362MT), an exit combo unit (LU36C) or a 2-LED 15 W kit (LALED). Under "Accessories" at the bottom of the page.

The texts coloured in green correspond to hyperlinks leading to specific safety equipment or to a general information link.