Harness for LED strip lights (item CBD322R)

Connection harness for the CBD322R LED strip of Baghelli Exit signs

The harness (LCBD322R) is the 12-inch wiring loom that powers the CBD322R LED strip in Baghelli brand emergency "Exit" lighting units. It is the part that electrically connects the light bar to the sign's circuit: when a loom is damaged, cut or its connector is worn, replacing it restores a reliable power feed to the LED strip without touching the rest of the unit. A loom in good condition ensures the sign lights up correctly, both on mains power and in battery mode during an outage.

Keeping the original connection part avoids improvised wiring that can compromise the reliability of safety signage. This harness is designed as a direct replacement part for the CBD322R strip, simplifying maintenance and reducing the risk of a wiring error during service.

Benefits of the connection harness for the LED strip

Beyond its wiring function, this harness secures the operation of the Exit sign and makes maintenance easier.

Reliable power feed to the LED strip

An intact loom ensures a stable electrical contact between the sign and the light bar, preventing flicker, loss of lighting or a failure to switch to emergency mode.

Direct compatibility with the Baghelli CBD322R strip

Designed specifically for the CBD322R LED strip of Baghelli units, this 12 in. harness installs as a direct replacement for the original loom, with no adaptation.

Worksites and sectors where this harness is required

Replacing an Exit sign loom is required everywhere evacuation signage must remain reliable:

• Commercial buildings, offices and apartment buildings equipped with Baghelli Exit signs.
• Institutional facilities (schools, hospitals, long-term care homes) subject to emergency lighting requirements.
• Stores, restaurants and hotels that must keep their exits clearly marked.
• Industrial buildings and warehouses subject to emergency lighting system inspection.
• Any technician replacing a faulty loom while troubleshooting a sign.

Installation and maintenance of the connection harness

Replacement involves disconnecting the old loom and connecting the new harness between the sign's circuit and the CBD322R LED strip. Installation is not included and must be performed by a qualified person with the sign de-energized. After fitting, an emergency-mode test confirms the LED strip lights up correctly and that no contact is intermittent.

FAQ about the harness for the CBD322R LED strip

What is this harness for?

It electrically connects the CBD322R LED strip to the Baghelli Exit sign circuit. It is the connection part that powers the light bar.

How long is the harness?

The harness is 12 inches long, designed for the CBD322R strip of Baghelli units.

Is installation included?

No, installation is not included. The harness is supplied as a replacement part to be fitted by a qualified person.

Suggested complementary emergency lighting equipment

Replacing a loom often goes with replacing the light bar and maintaining the sign; to complete the repair, also see a Baghelli LED bar (LCBD142), a 17 in. multivoltage strip (LCB071433), an Exit sign with battery (LUMB), a replacement battery (LBLUM), a single 9 W spotlight (LUMT1), a 6 V 36 W unit (LU362MT), an exit combo unit (LU36C) or a 2-LED 15 W kit (LALED). Under "Accessories" at the bottom of the page.

The texts coloured in green correspond to hyperlinks leading to specific safety equipment or to a general information link.