Peakworks Peakpro harness 1 Ring, universal size, quick connect buckles, class A

Peakpro safety harness by Peakworks, class A, with one back D-ring and quick connect, universal size. This type of harness is for workers who are looking for comfort. Designed for regular construction work, maintenance, etc.

Peakworks product code: V8006100 or model FBH-60110A.
Complies with CSA standard Z259.10-06 and et ANSI Z359.11.

This harness can support a maximum weight of 400 lb (180 kg), including clothing, tools, etc.

This Peakworks safety harness is made of woven non-stretch polyester. The Peakworks safety harness is made with high visibility colored polyester webbing. In addition, they have distinct colors for easy donning. The straps are padded on the shoulders, back and legs to provide more comfort for workers. To improve safety, this harness is equipped with a sub-pelvic strap. Polyester straps offer better resistance to acidic chemicals.

The chest and thigh straps are joined by quick release buckles. This harness has 5 adjustment points: 2 on the legs, 2 on the torso and 1 on the chest. Also includes trauma straps to allow the fallen worker to stand up while awaiting recovery and avoid losing consciousness. Product identification and certification labels are sewn onto the back straps on the left side of the safety harness. It includes a fall indicator for easy inspection.

Inspection:

The worker is responsible for visually inspecting the harness before each use. During this routine inspection, the worker must note any signs of degradation, malfunction, or breakage. The harness will have to be replaced if any such signs are detected.

On top of this routine inspection, the harness must be inspected by a qualified person different than the worker that wears the harness. The frequency of these inspections varies according to the manufacturer. Some manufacturers require an inspection every 90 days, others every 180 days, or even yearly. These inspections should be performed more often if the harness is worn in extreme environmental working conditions.

The recommended lifetime of a safety harness if 5 years. While some manufacturers keep silent on this topic, in practice, if the harness is used regularly and stored and maintained in standard conditions, its lifetime will not exceed 5 years in most cases.

Sylprotec offers a safety harness inspection service. Find out more by clicking on the Services tab, under the Sylprotec logo at the top of the page.

Any equipment that has withstood a fall or an impact must be scrapped.

Maintenance:

For cleaning, use a gentle soap or detergent and lukewarm water (37°C). Do not use bleach, chlorine, or other abrasive or chemical products. If your harness is too dirty or contaminated, it is time to replace it. Air dry without using heat, in a clean environment. You can accelerate the drying process by wiping the wet harness with a clean absorbent wipe, or by using a fan. Avoid exposing the harness to sunlight and to any sources of contamination.

Suggestion:

To complete your fall protection you will find a range of lanyards, retractable and anchors. Some products are suggested under the "accessories" tab at the bottom of this page.

Other equipment frequently used with this safety harness:

Safety glasses YA12E93101DX
Liberty TA14LR safety helmet and the essential TA14CS chin strap
EPTCONE28 Traffic Cones
Peakworks FPBAG storage bag
The FPL9900 Tool Strap

The texts coloured in green correspond to hyperlinks leading to specific safety equipment or to a general information link.