compare_arrows

Heavy-traffic floor tape, yellow/black, 100 ft

Reference : ECTHDJN-2
$267.80

This item is not kept in stock. Please allow 5 days for delivery.

Yellow/black striped floor marking tape to signal hazard zones, forklift lanes, machine surroundings and loading docks, available in 100 ft rolls in a 2, 3 or 4 in width. Made of 0.050 in (50 mil) striped PVC protected by a surface layer, it resists abrasion, chemical exposure and scuffing. Its beveled edges limit lifting when wheels pass, and its high-tack adhesive bonds to clean, dry, smooth floors.

Width: 2 in
Quantity

Compare

Heavy-traffic floor tape, yellow/black, 100 ft

This item is not kept in stock. Please allow 5 days for delivery.

Available widths: 2 in, 3 in and 4 in, 100 ft roll

Available in 3 widths. Select the variant you need from the drop-down menu.

Sylprotec codeWidthLengthWeight
ECTHDJN-22 in (5.08 cm)100 ft (30.48 m)6 lb (2.72 kg)
ECTHDJN-33 in (7.62 cm)100 ft (30.48 m)9 lb (4.08 kg)
ECTHDJN-44 in (10.16 cm)100 ft (30.48 m)11 lb (4.99 kg)

The dimensions shown are for variant ECTHDJN-2.

This floor tape with yellow and black stripes draws the eye to critical spots: forklift and vehicle lanes, machine surroundings, loading docks, transit areas and 5S zones. It is made of 0.050 in (50 mil) striped PVC, protected by a surface layer that extends its service life under wear, chemical exposure and repeated equipment traffic. Its beveled edges reduce the impact of wheels, and its high-tack rubber-based adhesive bonds to most clean, dry, smooth floors. The 100 ft (30.48 m) roll comes in a 2 in (5.08 cm), 3 in (7.62 cm) or 4 in (10.16 cm) width. It is made in the United States.

Features of the yellow/black striped floor tape

  • Highly contrasting diagonal yellow and black stripes to signal hazards.
  • 0.050 in (50 mil) PVC with a protective surface layer.
  • Beveled edges that limit lifting when wheeled equipment passes.
  • High-tack rubber-based adhesive for lasting adhesion.
  • Resistance to abrasion, chemical exposure and scuffing; removes cleanly with minimal residue.

Yellow/black striped floor tape applications

The manufacturer recommends it for forklift and vehicle traffic zones, hazard awareness and marking off safety zones, warehouse aisles and industrial workflow organization, as well as loading docks, transit areas and 5S zones. The 2 in width suits narrower areas, the 3 in width stays clearly visible around a hazard area, and the 4 in width is seen from farther away along forklift lanes. This page carries yellow/black stripes only; the 3 in width exists only in this colour. The same series comes on sister pages, each in 2 and 4 in: the yellow roll (ECTHDJA), the blue strip (ECTHDBL), the red variant (ECTHDRG), the green version (ECTHDVE), the white model (ECTHDBC), the black product (ECTHDNO) and the red/white striped option (ECTHDRB).

Yellow/black striped floor tape technical specifications

FeatureDetail
ColourYellow and black stripes
MaterialStriped PVC, protective surface layer
Thickness0.050 in (50 mil, 1.27 mm)
Widths2 in (5.08 cm), 3 in (7.62 cm) or 4 in (10.16 cm)
Length100 ft (30.48 m) per roll
EdgesBeveled
AdhesiveRubber-based, high tack, heavy coat weight
Application surfaceClean, dry, smooth floor
Country of originUnited States
Sold byRoll

Striped floor tape installation and care

Sweep and clean the floor, then let it dry. Unroll the tape around the area to flag, cut it to length and press it firmly across its full width, right to the edges. Sweep regularly to keep the stripes visible, and replace any section with a lifting edge or too worn. When the layout changes, the tape removes cleanly from most surfaces with minimal adhesive residue.

FAQ: yellow/black striped floor tape

What are the yellow and black stripes for?

The contrast of the stripes draws attention to hazard zones: machine surroundings, forklift lanes, loading docks and areas where caution is required. The manufacturer intends it for hazard awareness and marking off safety zones.

Which width should I choose?

The 2 in suits narrower areas. The 3 in stays clearly visible around a hazard area. The 4 in is seen from farther away along forklift lanes. Also follow the marking rules of your facility.

Does it stand up to forklift traffic?

Yes. Its beveled edges limit lifting when wheels pass, and its 0.050 in PVC, protected by a surface layer, resists abrasion, chemical exposure and scuffing.

What floors can it be applied to?

Most clean, dry, smooth floors. Clean and dry the surface before application for good adhesion.

Can it be removed if the layout changes?

Yes. It removes cleanly from most surfaces with minimal adhesive residue.

Suggestions for the yellow/black striped floor tape

For the technician who marks machine surroundings and loading docks on their knees, plan for the Ultra Flex (VG106) III articulated knee pads, the TenActiv (GSTAFGFNT) ASTM/ANSI level A4 cut-resistant gloves with foam nitrile coating, the 3M (YASF201) SF201 SecureFit safety glasses, the economical (VV57) high-visibility orange surveyor vest with 11 pockets and the Max Lite (OA1102) uncorded disposable earplugs against machine noise.

To complement your equipment: Zenith yellow and black anti-skid tape, 60 ft roll (ECT749JN); “AUTHORIZED PERSONNEL ONLY” adhesive anti-skid laminated vinyl floor sign, various sizes & languages (EDPER) and Acrylic half dome convex mirror, for 180-degree view in a T-intersection (M88).

The texts coloured in green correspond to hyperlinks leading to specific safety equipment or to a general information link.

ECTHDJN-2

Data sheet

Product group
Safety equipment
Main category
Sign and lock
Sub category
Cones and barricade tapes
Name of the product
Marking tape
Product code
ECTHDJN
Sort by keywords
Marking tapes
Product use
Floor marking
Manufacturer
Incom Direct
Country of origin
United States of America
Thickness in mils
50 mils
Choice of format
2, 3 and 4 in
Features
To mark aisles and forklift lanes on the floor
Additional Features
Beveled edges
Mounting type
Permanent adhesive back
Material
Chlorinated polyvinyl (PVC)
Length (ft/m)
100 ft / 30.48 m
Length (in/cm)
12 in / 30.48 cm
Width (in/cm)
12 in / 30.48 cm
Height (in/cm)
2 in / 5.08 cm
Weight (lb/kg)
6 lb / 2.7 kg
Sold by
Roll
Color
Yellow/Black
HS Code
3919102055
Return conditions
Not returnable if used. For more information about our return policy, please refer to the "Orders and Returns" link on the home page
Caution
Apply to a clean, dry, smooth floor

Specific References

MPN
AS250

You might also like

Comments (0)
No customer reviews for the moment.