Striped warning adhesive tape, red and white 2 in X 48 ft (50 mm X 16 m).

Red and white adhesive warning tape 2 in x 48 ft

The ECT750R adhesive warning tape helps visually mark an area, passage or boundary that needs attention. Its red and white striped pattern creates clear contrast to frame an access point, identify an area to watch or complete indoor or sheltered marking. The tape is 2 in wide and 48 ft long, or 50 mm x 16 m according to the existing product information.

Printed on PVC adhesive tape and covered with a clear film, it combines visibility, adhesion and surface protection for common safety marking uses. Product code: ECT750R.

Features of the ECT750R warning tape

This adhesive marking tape provides a simple visual indication for traffic and work areas.

• Product code: ECT750R.
• Type: adhesive warning tape.
• Colour: red and white.
• Width: 2 in / 5.08 cm.
• Indicated length: 48 ft / 16 m.
• Indicated material: PVC.
• Finish: printed and covered with a clear film.
• Structured weight: 0.75 lb / 0.34 kg.
• Sold by unit.

Applications for passages, access points and marked areas

The ECT750R tape is suited to visual marking of passages, doors, machine surroundings, service access points, floors and work areas where a red and white contrast helps attract attention. It can define a zone or reinforce an existing visual instruction.

Application, surface and red and white tape maintenance

Apply the tape to a clean, dry surface compatible with the adhesive. Press firmly along the full length to promote adhesion, then inspect the edges, wrinkles and wear regularly. Replace the tape when it lifts, loses contrast or no longer clearly signals the intended area.

FAQ about red and white adhesive tape

What size is the ECT750R tape?

The product information indicates 2 in x 48 ft, or 50 mm x 16 m.

What is the red and white pattern for?

It creates warning contrast to mark a boundary, passage, access point or area that needs attention.

Is the tape adhesive?

Yes. The product information indicates PVC adhesive tape.

Where can it be used?

It can be used on passages, access points, floors and work areas when the surface is clean and compatible with the adhesive.

When should it be replaced?

Replace it if it lifts, tears, loses contrast or no longer provides clear visual marking.

Suggestions to complete marking and traffic safety

For other marking tapes, the warning tape (ECT750) offers a black and yellow combination, the anti-slip model (ECT749) adds a traction surface, the black tape (ECT748) suits low-traffic areas, and the danger barricade tape (ECT3RE9) is used for temporary marking.

To complete a traffic area, the line with flags (EFLAC) defines a perimeter, the yellow yellow tape (ECT3YE7) adds another marking colour, the cone (EPTCONE) marks corners or passages, and the wet floor sign (ETR01) warns of a wet floor.

The texts coloured in green correspond to hyperlinks leading to specific safety equipment or to a general information link.