White aluminum placard holders

White aluminum placard holders, for 10-3/4 in X 10-3/4 in placards

This item is not kept in stock. Please allow 5 days for delivery.

This white-finish aluminum slide-in placard holder showcases the TDG placard: the bright white creates strong contrast and makes the hazard information easier to read from a distance. A formed ramp guides the placard under the stainless steel clip, which holds it firmly and releases it easily. Raised bumps on the back plate keep plastic placards from freezing or sticking in winter, and ten pre-drilled holes make installation quick. Made in Canada, it is sold individually.

Features of the white aluminum placard holder

• Durable white-finish aluminum and stainless steel clip.
• High-contrast white finish that improves placard readability.
• Formed ramp that guides the placard into place and eases removal.
• Raised bumps on the back plate against placards sticking in cold weather.
• Three configurations: standard, split or clipped corners for roll-up doors.

Available configurations: standard, split or clipped corners

White placard holder applications

The white placard holder is used for TDG display on trucks and trailers, hazard communication in logistics and shipping, and facility compliance. It suits dark-coloured vehicles and buildings, where the white makes the placard stand out. It takes any 10-3/4 in tagboard or rigid plastic placard.

Depending on the load, apply the adhesive vinyl marine pollutant mark (ECLAPM) separately to a suitable surface. The five-legend placard (ECLAP5) is a standalone unit, not an insert for this holder. Low-profile clips (ECLAPINB100) and the white face plate (ECLAFACADEBC) are sold separately.

White placard holder technical specifications

Mounting the white holder and checking clip tension

Mount the placard holder on a flat surface through its pre-drilled holes, with hardware suited to the vehicle (not included). Slide the placard along the ramp until it sits under the clip. Wash the white finish with soapy water to keep the contrast, and check clip tension at every inspection.

FAQ: white aluminum placard holder

Why a white placard holder?

The bright white finish creates strong contrast that makes the placard easier to read from a distance, according to the manufacturer.

Which configuration should I choose for a roll-up door?

The split version (ECLAPBL-OUV) or the clipped corner version (ECLAPBL-CO), designed for roll-up doors.

Which placards does the placard holder accept?

10-3/4 X 10-3/4 in tagboard or rigid plastic placards.

Can the clip be replaced?

Yes. The low-profile stainless spring clips (ECLAPINB100) are sold in packs of 100.

Is there an unpainted aluminum or stainless steel version?

Yes: the standard aluminum placard holder (ECLAP) and the stainless steel placard holder (ECLAPINOX).

Suggestions for TDG display on vehicles

Need complementary safety equipment for placard installation and maintenance? Consider the glasses (YA12E93101) with clear Cee Tec lenses, the gloves (GS15NT) with Dexterity NT nitrile coating for handling, the vest (V6672) for orange high-visibility surveyor wear, the boots (VC8040B) with waterproof StepliteX construction, and the kneepads (VG104) in flexible rubber for work at floor level.

Under “Accessories” at the bottom of the page. Looking for complementary equipment? Consider the cone (EPTCONE28) in the 28 in size for marking the work area, the removable reflectors (EPTR) for marking a stopped vehicle, and the road safety kit (TR16) to complete its supplies.

The texts coloured in green correspond to hyperlinks leading to specific safety equipment or to a general information link.