Zenith recycled rubber speed bump, 6 ft X 11-3/4 in X 2 in

Zenith recycled rubber speed bump, 6 ft X 11-3/4 in X 2 in

Manufacturer code Zenith: SEH143, model SEH143

This item is not kept in stock. Please allow 15 days for delivery.

The Zenith SEH143 speed bump reduces speed in parking lots, school zones and areas with heavy pedestrian traffic. Made in one piece of lightweight 100% recycled rubber, it measures 6 ft (72 in) long, 11-3/4 in wide and 2 in high, and weighs 55 lb. It resists corrosion, moisture, oil, weather variations and UV light. Black, it carries bright yellow reflective stripes for daytime visibility and reflectors for nighttime visibility. Its capacity is approximately 18 tons at 10 km/h. It installs permanently or temporarily with 4 rebar spikes of 14 in, sold separately. Made in China, it is covered by a 1-year limited warranty.

Features of the Zenith SEH143 speed bump

• One-piece 100% recycled rubber
• 6 ft X 11-3/4 in X 2 in, 55 lb
• Reflective yellow stripes and reflectors for nighttime
• Capacity of approximately 18 tons at 10 km/h
• 4 required 14 in rebar spikes, sold separately

Applications of the Zenith SEH143 speed bump

In a parking lot, near a school or wherever pedestrians and vehicles often cross paths, the Zenith SEH143 speed bump gets drivers to slow down. Plan for 4 rebar spikes of 14 in per bump for a permanent or temporary installation.

Care of the Zenith SEH143 speed bump

Periodically check that the rebar spikes hold the speed bump firmly. Clean the yellow stripes and the reflectors to keep it visible by day and by night.

FAQ: the Zenith SEH143 speed bump

Are the anchor spikes included?

No. The speed bump is sold alone: it needs 4 rebar spikes of 14 in, sold separately.

What load can it take?

Approximately 18 tons at 10 km/h, according to the manufacturer.

What are its dimensions?

6 ft (72 in) long, 11-3/4 in wide and 2 in high, for 55 lb.

Is it visible at night?

Yes. Reflectors provide nighttime visibility and bright yellow stripes provide daytime visibility.

Does it stand up to the weather?

Yes. It resists corrosion, moisture, oil, weather variations and UV light. It is made in China and covered by a 1-year limited warranty.

Suggestions for this Zenith SEH143 speed bump

For the grounds worker installing this Zenith speed bump at a parking lot entrance, plan for yellow high-visibility overalls (VV55JP) with retroreflective stripes, 3M SecureFit 400 safety glasses (YASF407BG) with a gray anti-fog lens, reinforced cut-resistant Tenactiv gloves (GS21TXUFNLTC) with a nitrile foam coating, a 3M 8576 respirator (R8576) with a Cool Flow valve against site dust, an elastic polyester 2-point chinstrap (TA80CS) that fits most hard hats and a cone barrel base (EPTBAB) to channel traffic around the work zone.

The 4 Zenith 14 in galvanized rebar spikes (EPTDA) required for installation are sold separately. For a kit supplied with end caps and spikes, see the other 6 ft Zenith speed bump (EPHF709). During the work, mark off the area with a strobe lamp (LL2304) placed on a cone and the Zenith portable mobile barrier (EPT4013), and protect cables crossing the lane with a Pioneer 5-channel cable protector (PC287).

The texts coloured in green correspond to hyperlinks leading to specific safety equipment or to a general information link.