Aluminum placard holders

Aluminum placard holders, for 10-3/4 in X 10-3/4 in placards

Standard: in stock at Sylprotec. Other formats: please allow 5 days for delivery.

This aluminum slide-in placard holder displays a 10-3/4 X 10-3/4 in tagboard or rigid plastic TDG placard and lets you change it in seconds. A formed ramp guides the placard under the stainless steel clip, which holds it firmly and releases it easily. Raised bumps on the back plate keep plastic placards from freezing or sticking in winter. Its ten pre-drilled holes make installation quick and secure. Made in Canada, it is sold individually.

Features of the aluminum placard holder

• Quality aluminum and stainless steel clip, for a long service life.
• Formed ramp that guides the placard into place and eases removal.
• Raised bumps on the back plate against placards sticking in cold weather.
• Ten pre-drilled mounting holes for fast, secure installation.
• Three configurations: standard, split or clipped corners for roll-up doors.

Available configurations: standard, split or clipped corners

Aluminum placard holder applications

The placard holder is used for TDG display on trucks and trailers, hazard communication in logistics and shipping, and facility compliance. The split and clipped corner versions are designed by the manufacturer for roll-up doors. It takes any 10-3/4 in tagboard or rigid plastic placard.

Complete your display with a placard such as the diesel fuel UN1202 (ECLA1202) placard or the marine (ECLAPM) pollutant placard, and the low-profile replacement clips (ECLAPINB100). The aluminum face plate (ECLAFACADEAL) is also sold separately.

Aluminum placard holder technical specifications

Placard holder installation and care

Mount the placard holder on a flat surface through its pre-drilled holes, with hardware suited to the vehicle (not included). Slide the placard along the ramp until it sits under the clip. Check clip tension at every inspection and replace the clip if it no longer holds the placard well.

FAQ: aluminum placard holder

Which placards does the placard holder accept?

10-3/4 X 10-3/4 in tagboard or rigid plastic placards.

Which configuration should I choose for a roll-up door?

The split version (ECLAP-OUV) or the clipped corner version (ECLAP-CO), both designed by the manufacturer for roll-up doors.

Does the placard stick to the holder in winter?

The raised bumps on the back plate keep plastic placards from freezing or sticking, which makes replacement easier year-round.

Can the clip be replaced?

Yes. The low-profile stainless spring clips (ECLAPINB100) are sold in packs of 100.

Is there a white or stainless steel version?

Yes: the white aluminum placard holder (ECLAPBL) and the stainless steel placard holder (ECLAPINOX).

Suggestions for TDG display on vehicles

For the driver or mechanic who mounts placard holders and changes placards, plan for SecureFit anti-fog safety glasses (YASF201), cowhide gloves (G300) with tough cuffs, a yellow Pioneer mesh-back safety vest (V6936), TurboToe PVC overshoes (VC8021) with steel toe caps and Impacto hard shell knee pads (VG101).

At the roadside, signal the vehicle with the three removable reflectors (EPTR) and a 28 in traffic cone (EPTCONE28B). The UK4AA-eLED anti-explosion flashlight (LL01), intrinsically safe Class 1 Div 1, provides light safely near a load of dangerous goods. A truck driver is an isolated worker as defined by the CNESST: the personal (TR01) first aid kit is suitable when medical services can be reached in less than 30 minutes; far from medical services, plan for the basic (TR02M) first aid kit. Also keep the portable road (TR16) safety kit on board.

The texts coloured in green correspond to hyperlinks leading to specific safety equipment or to a general information link.