Easy-access aluminum placard holder with protective shield

Easy-access aluminum placard holder with protective shield

This item is not kept in stock. Please allow 5 days for delivery.

In winter or on muddy job sites, a dirty or frozen placard quickly becomes illegible and hard to change. This heavy-duty aluminum placard holder keeps the placard clean and visible: a clear protective shield covers it during transport and keeps dirt, snow and moisture from building up. Two stainless steel clips hold the shield and placard, and the holder's design allows quick replacement, even when frozen. It is sold individually.

Features of the easy-access placard holder

• Rigid 0.040 in aluminum base, highly durable.
• Clear PETG protective shield included, covering the placard.
• Two stainless steel clips holding the shield and placard.
• Quick placard replacement, even when frozen or muddy.
• For 10-3/4 X 10-3/4 in tagboard or rigid plastic placards.

Easy-access placard holder applications

The manufacturer recommends it for extreme weather: trucks and trailers in winter, off-road or muddy job site transport, and any TDG display exposed to the weather. The shield (ECLAECR) is sold separately, as are the high-profile replacement clips (ECLAPINH100).

Complete your display with the mixed (ECLAD) loads danger placard or the rigid plastic class 3 placard with a blank (ECLA3UN) UN box.

Easy-access placard holder technical specifications

Installing the shielded holder and maintaining both clips

Mount the placard holder on a flat surface of the vehicle with suitable hardware (not included). Slide the placard under the clips, then the shield on top. Clean the shield to keep the placard legible and replace it if it is scratched or cracked. Lubricate the clips as needed and replace them if they lose tension.

FAQ: easy-access placard holder with shield

Is the protective shield included?

Yes. The clear PETG shield is included; the replacement (ECLAECR) is offered separately.

Which placards does it accept?

10-3/4 X 10-3/4 in tagboard or rigid plastic placards.

Can the placard be changed when frozen?

Yes. According to the manufacturer, its design allows quick replacement, even when frozen or muddy.

Which replacement clips should I use?

The high-profile stainless spring clips (ECLAPINH100), sold in packs of 100.

What are its dimensions?

12.5 X 12.5 X 0.5 in (31.75 X 31.75 X 1.27 cm).

Suggestions for TDG display in severe conditions

Need complementary safety equipment for placard installation and maintenance? Consider the glasses (YA11329) with clear Virtua Max lenses, the gloves (GMXVSB) with impact protection for mechanic tasks, the vest (V6931) for yellow high visibility, the toe caps (VC8021) in TurboToe steel for toe protection, and the kneepads (VG104) in flexible rubber for work at floor level.

Under “Accessories” at the bottom of the page. Looking for complementary equipment? Consider the cone (EPTCONE28) in the 28 in size for marking the work area, the removable reflectors (EPTR) for marking a stopped vehicle, and the road safety kit (TR16) to complete its supplies.

The texts coloured in green correspond to hyperlinks leading to specific safety equipment or to a general information link.