Second stage filter for particles 5 um and plus

High-precision decontamination filter for fine particles

Second stage filter for particles 5 µm or bigger. Designed for the filtration pump unit that goes on S5000 series TeleShower (SAH6) for asbestos decontamination.

The Teleshower SAH6PFS secondary filter is specifically designed for filtration pumps used in asbestos decontamination showers, series S5000. It serves as the second stage in the filtration process, capturing particles of 5 µm and larger present in the wastewater. While the primary filter retains particles of 25 µm and larger, the secondary filter takes over to eliminate finer particles, thus ensuring complete and effective filtration. This complementarity between the two filters enhances the overall performance of the Teleshower system.

 Most particles bigger than 25 µm don’t make it through the first filter (SAH6PF)

Performance and enhanced safety

Technical specifications of the Teleshower secondary filter:

This filter is designed to operate with the Teleshower filtration pump model SAH6. It captures particles of 5 microns and larger, contributing to the retention of asbestos fibers in decontamination water. Its structure allows for two-stage filtration, reducing the risk of saturation and extending the system’s lifespan. This filter is non-returnable once used, due to potential contamination by asbestos fibers.

Installation of the secondary filter for Teleshower pump:

Installing the Teleshower secondary filter is simple and secure. It fits into the designated compartment of the SAH6 pump, after the primary filter. It is essential to follow safety instructions during handling, including wearing appropriate personal protective equipment. Proper installation ensures a perfect seal and optimal filtration performance.

Maintenance of the 5 µm secondary filter for decontamination shower:

After use, the filter contains potentially hazardous fine particles, including asbestos fibers. It must be removed with care and disposed of in accordance with contaminated waste management protocols. Regular replacement of the filter is recommended to maintain system efficiency. Thorough maintenance of the pump and its components helps extend the equipment’s lifespan.

Safe use of the Teleshower secondary filter:

This filter is intended for professionals working in areas contaminated by asbestos. It must be used exclusively with the Teleshower SAH6 pump and within a strict decontamination protocol. Compliance with safety standards and installation and removal procedures is essential to ensure optimal protection for users and the environment.

FAQ – secondary filter for 5 µm particles Teleshower:

 What is the function of the Teleshower secondary filter?

It captures particles of 5 µm and larger in the wastewater from decontamination showers, complementing the action of the primary filter.

Is this filter compatible with all filtration systems?

 No, it is specifically designed for the Teleshower filtration pump model SAH6, series S5000.

How should a used secondary filter containing asbestos fibers be disposed of?

It must be handled with care and disposed of according to hazardous waste management protocols, in compliance with current regulations.

Additional suggestions of the Teleshower secondary filter:

Need additional safety equipment? See the articles; Safety hard hat (TA14LR), Omega II minor hard hat type 1 (TA14FS), motorized respirator with 1000 protection factors (R6800PF), 3M  mask protection film (R6885).

Under "Accessories" at the bottom of the page. If you're looking for work equipment, have a look at the following products: White antistatic coveralls with (V51), containment fabric or (SAH2MA) air cleaners (SACTT2).

The texts coloured in green correspond to hyperlinks leading to specific safety equipment or to a general information link.