G203

Cotton terry glove for men with an "Oil-bloc" nitrile lining ANSI heat resistant 3. THT™ design by Superior. Sold by the pair.

$39.80

Return conditions : No returnable if used. For more information about our return policy, please refer to the "Orders and Returns" link on the home page

8 only in stock, discontinued product.

Cotton terry with oilblock nitrile lining glove, ANSI heat resistant level 3. Sold by the pair. Model for men.

These gloves are available in two sizes: woman (7) or man (9). Please select the size needed in the field located above.

Superior manufacturer’s code: TRKONB

These cotton terry gloves are equipped with a nitrile lining which covers the whole surface of the palmar side of the glove. This layer basically covers the inside of the hand and is not design to withstand full submersion. Liquids are essentially absorbed from all over the glove, but when it comes to oils, the worker’s skin is only protected on the palmar side of the hand, not on the back of the hand.

These knitted gloves are designed accordingly to Superior’s ‘True Hand Technology’ or THT™. This design perfectly fits the hand, since it respects takes into account the human hand physiognomy, that is, the crotch between the little finger and the ring finger is located just a little lower than the other finger crotches.

These gloves are perfect to handle wet surfaces or oily parts. The terry knit fabric is quite absorbent, especially when it comes to oils and will offer a good dexterity.  This is why this glove is recommended for workers of the metalworking industry and those dealing with oily parts handling.

This glove is also conform to level 3 accordingly to the ANSI  heat resistance standard.

Maintenance and life service:
It is recommended to carry out a basic maintenance to extend the service life of your gloves. Simply wash them with hot water, that is, 105°F/40°C and a regular detergent. You can then dry them at medium temperature in a dryer. If needed, you may use bleach to remove the stains, but it is not required nor recommended to bleach your gloves every time you wash them.

Type of productSafety equipment
Main categoryPersonal protection
Sub categoryGloves
Sub sub categoryHeat-resistant gloves
Name of the productCoolgrip
Product codeG203
Approved/CertifiedANSI 3 cut heat
ManufacturerSuperior gloves
Choice of formatSize small (7) and large (9) available
FormatFor men
Recommended use temperatureHeat protection up to 392°F / 200°C
FeaturesKnitting THT(Tm) (True Hand Technology) design adapted to the human hand
MaterialCotton terry with Oil-bloc nitrile lining
WashableSimply wash them with lukewarm water (140°F/60°C) and a regular detergent. Rinse your glove with cold water. Dry them at low temperature in a dryer. If needed, these glove can be bleached
Length (in/cm)16 in / 40.6 cm
Width (in/cm)4 in / 10.16 cm
Height (in/cm)0.5 in / 1.27 cm
Weight (lb/kg)0.5 lb / 0.22 Kg
Sold byPair
ColorWhite
Return conditionsNo returnable if used. For more information about our return policy, please refer to the "Orders and Returns" link on the home page

Accessories

9 other products in the same category: