FPA822

Anti rollout D-shaped anchorage made to anchor fall protection equipment. Gate opening of 4 ¼ in. 5000 lbs resistant.

$45.25

Steel anti rollout D-shaped anchorage made for the anchorage of fall protection equipment. The major concern of using this device is to reduce rollout possibilities.                 

Dimensions

Connection opening: 4 ¼ in (197 mm)
Width: 2 15/16 in (75 mm)
Length: 2 13/16 in (71 mm)
Size of the bolt: ½ in (12.7 mm)

This product can resist hostile environments with rough temperatures from -40°F to 130°F (-40°C to 54˚C).

This product meets the standards ANSI A10.32, ANSI Z359.1-2007 and OSHA 1926.502, 1910.66. This type of carabiner can support a force of 5000 lbs (22 kN).

The worker is responsible for visually inspecting his equipment before each use. During this routine inspection, the worker must note any signs of degradation, malfunction, or breakage. The carabiner will have to be replaced if any such signs are detected.

On top of this routine inspection, the anchor must be inspected by a qualified person different than the worker. The frequency of these inspections varies according to the manufacturer. Some manufacturers require an inspection every 90 days, others every 180 days, or even yearly. These inspections should be performed more often if your equipment is used in extreme environmental working conditions.

Sylprotec offers a fall protection equipment inspection service. Find out more by clicking on the Services tab, under the Sylprotec logo at the top of the page.

Any equipment that has withstood a fall or an impact must be scrapped.

Bolt not included.

Reviews

No customer reviews for the moment.

Write a review
Anti rollout D-shaped anchorage made to anchor fall protection equipment. Gate opening of 4 ¼ in. 5000 lbs resistant.

Anti rollout D-shaped anchorage made to anchor fall protection equipment. Gate opening of 4 ¼ in. 5000 lbs resistant.

Accessories

19 other products in the same category: