Water stop for fire hose

ULC Water Stop for Fire Hose

The water stop for fire hose is a ULC-listed device that holds the water in the hose until it is completely unwound. It makes the use of fire hoses easier and safer by preventing water from flowing before the user is ready and positioned at the end of the hose. This simple but essential mechanism improves control during a response and reduces the risk of losing command of the pressurized water jet.

Designed to fit into the fire hose station, the water stop acts as a temporary water hold-back : once the hose is stretched and taut, a sharp pull releases the mechanism and lets the water fill the hose. It is a particularly useful accessory in buildings equipped with reel-mounted or wall-mounted hoses, where speed and control of deployment are decisive.

Benefits of the Fire Hose Water Stop

Beyond simply holding back water, the water stop contributes to the safety and efficiency of the response.

Water Control Until Full Deployment

By holding the water until the hose is fully unwound, the water stop prevents a partially deployed hose from becoming uncontrollable under pressure.

ULC Compliance and Reliability

ULC-listed, the water stop meets recognized fire safety standards, a mark of reliability for building inspections and regulatory compliance.

Buildings and Sectors Where This Water Stop Is Used

This accessory is found in many environments equipped with fire hoses :

• Commercial and institutional buildings with fire hose stations.
• Factories, warehouses and industrial sites.
• Indoor parking lots and service areas.
• Municipal facilities and residential buildings.

How to Use the Fire Hose Water Stop

Use is simple : once the hose has been unwound, the user stretches the hose and gives a sharp pull, which releases the water stop mechanism. Water then fills the hose once the user is positioned at the end and ready to hold the pressurized hose.

FAQ About the ULC Fire Hose Water Stop

What is a fire hose water stop for ?

It holds the water in the hose until it is completely unwound, allowing the user to control when the water starts to flow.

How is the water released ?

Once the hose is stretched and taut, a sharp pull releases the mechanism and lets the water fill the hose.

Is the water stop certified ?

Yes, this water stop is ULC-listed, confirming its compliance with recognized fire safety standards.

Suggested Complementary Equipment for Fire Hose Stations

To set up a complete fire hose station, see also a circular reel (IBD18), a standard 24 in model (IBD24), a horizontal reel (IBD100), a protective cover (IBC75), a hydrant cover (CEBORA), a combination wrench (ICC250H), a universal spanner (ICC15) or a recessed cabinet (BC100). Under "Accessories" at the bottom of the page.

The texts coloured in green correspond to hyperlinks leading to specific safety equipment or to a general information link.