DBI-SALA 3M Trigger2Trigger Tool Tether

Falling Object Protection: The Trigger2Trigger Tool Tether

The DBI-SALA 3M Trigger2Trigger tool tether is designed to secure tools and accessories while working at height, reducing the risk of dropped objects that can cause injury and damage. It is sold in a pack of 10 and available in 12 in, 24 in or 36 in, depending on selection.

Its high-visibility yellow nylon webbing features steel swivel snap hooks at both ends, allowing the attached tool to rotate freely without tangling the tether. Load capacity of 10 lb (4.5 kg) per tether.

Manufactured in Taiwan, this tool tether is designed for construction work where a dropped tool at height presents a serious risk to workers below.

FAQ: Trigger2Trigger Tool Tether

How many tethers are included in a pack?

Each pack contains 10 tool tethers, allowing multiple work stations to be equipped quickly.

Which length should I choose?

The length depends on the distance between the tool's attachment point and the harness or work position; 12 in suits light tools held close, while 24 or 36 in offer more reach for tools handled at arm's length.

Does this tether suit all tools?

It suits tools weighing up to 10 lb (4.5 kg); heavier tools require a higher-capacity device.

How is the tether attached to a tool without a ring or loop?

A compatible Trigger2Trigger adapter or attachment strap must be installed on the tool before connecting the tether.

Can this tether be used for worker fall protection?

No, it is designed solely to secure tools and accessories, never to protect a worker against falls.

Complementary Suggestions for This Tool Tether:

The worker at height using this tool tether completes their equipment with a high-visibility shirt (VV44), cut-resistant gloves (GS13KFNT) for tool handling, a safety helmet (TA82) with its chin strap (TA80CS) to guard against dropped objects, safety glasses (YASF407BG) and a spare pair of backup (GS13SXGPU) for equipment rotation.

To fully equip the work position, add an ExoFit harness (FPH111321XXALP) or a belted (FPH111344XALP) model, a permanent stainless steel anchor (FPA826), and a fall protection equipment bag (FPBAG). A bag (FPBAG) helps store and carry all the equipment. Also plan for a height rescue device Rollgliss R550 controlled descent (FPLR5503325, adapted rope length), and barricade the work zone with a tape DANGER barricade tape (ECT3RE9) and a cone traffic cone (EPTCONE).

The texts coloured in green correspond to hyperlinks leading to specific safety equipment or to a general information link.