Peakworks polyester sling anchor with steel ring, one loop and variable size

Cross-Arm anchorage strap for fall protection. This strap has a small ring to connect the connecting link to an anchor point. One finds at the other end a choke-off loop. It is made of 1-15/16" (4.9 cm) woven polyester.

Peakworks manufacturer's code: V8209504, model: cas4-4 for the 4' size.

This mooring strap is available in different lengths ranging from three (3 ft), four (4') or six (6'). Please select your size from the drop down menu above.

According anchorage strap is designed to withstand a tensile strength of 5000 lb (22 kN) which meets CSA Z259.15, ANSI Z359.1-2007

Inspection:

The worker is responsible for visually inspecting his equipment before each use. During this routine inspection, the worker must note any signs of degradation, malfunction, or breakage. The anchor will have to be replaced if any such signs are detected.

On top of this routine inspection, the strap must be inspected by a qualified person different than the worker. The frequency of these inspections varies according to the manufacturer. Some manufacturers require an inspection every 90 days, others every 180 days, or even yearly. These inspections should be performed more often if your equipment is used in extreme environmental working conditions.

Sylprotec offers a fall protection equipment inspection service. Find out more by clicking on the Services tab, under the Sylprotec logo at the top of the page. Any equipment that has withstood a fall or an impact must be scrapped.

Maintenance:

For cleaning, use a gentle soap or detergent and lukewarm water (37°C). Do not use bleach, chlorine, or other abrasive or chemical products. If your harness is too dirty or contaminated, it is time to replace it.

Air dry without using heat in a clean environment. You can accelerate the drying process by wiping the wet lanyard with a clean absorbent wipe, or by using a fan. Avoid exposure to sunlight and to any sources of contamination.