FPAM88

Peakworks semi-automatic self-locking D-lock carabiner, 1" opening, withstands a force of 10125 lbs (45 kN)

$30.65

Return conditions : No returnable if used. For more information about our return policy, please refer to the "Orders and Returns" link on the home page

Semi-automatic carabiner requiring a double action to unlock. This Peakworks steel offset D-shaped snap hook with a 1 in (25.4 mm) throat opening is made for the anchorage of fall protection equipment.

It meets the CSA Z259.12 18C standard because it is capable of withstanding a force of 10125 lb (45 kN) without deforming. The rotary locking ring can withstand a force of 3600 lbs. This product also complies with ANSI Z359.12 standards.

Inspection:

The worker is responsible for visually inspecting the carabiner(s) before each use. During this routine inspection, the worker must note any signs of degradation, malfunction, or breakage. The carabiner will have to be replaced if any such signs are detected.

On top of this routine inspection, the carabiner must be inspected by a qualified person different than the worker. The frequency of these inspections varies according to the manufacturer. Some manufacturers require an inspection every 90 days, others every 180 days, or even yearly. These inspections should be performed more often if the carabiner is used in extreme environmental working conditions.

Sylprotec offers a fall protection equipment inspection service. Find out more by clicking on the Services tab, under the Sylprotec logo at the top of the page. Any equipment that has withstood a fall or an impact must be scrapped.

Maintenance:

For cleaning, use a gentle soap or detergent and lukewarm water (37°C). Do not use bleach, chlorine, or other abrasive or chemical products. Air dry without using heat in a clean environment. You may lubricate the door mechanism with powdered graphite when needed.

Suggestion:

To complete your fall protection you will find a range of harnesslanyards and self-retracting lanyards. Some products are suggested under the "accessories" tab at the bottom of this page.

Other equipment frequently used with this safety harness:

Safety glasses YA12E91001
Liberty TA14LR safety helmet and the essential TA14CS chin strap
EPTCONE28B Traffic Cones
Peakworks FPBAG storage bag
The FPL9901 Tool Strap

The texts coloured in green correspond to hyperlinks leading to specific safety equipment or to a general information link.

Type of productSafety equipment
Main categoryPersonal protection
Sub categoryFall protection
Sub sub categoryAnchorage & connectors
Name of the productSelf-locking semi-automatic carabiner
Product codeFPAM88
Approved/CertifiedComplies with CSA Z259.12-18C and ANSI Z359.12 standards
ManufacturerPeakworks
Country of originChina
ReusableReusable with careful inspection and proper installation
Features1" (25.4 mm) opening
Additional FeaturesRequires a double action to unlock and locks automatically
Characteristic adding safetyIt can withstand a force of 10125 lb (45 kN) without deforming. The rotary locking ring can withstand a force of 3600 lbs
FormAsymmetrical «D»
MaterialSteel
WashableHand wash with warm water and soap
Height (in/cm)0.5 in / 1.27 cm
Length (in/cm)5 in / 12.7 cm
Width (in/cm)3.5 in / 8.89 cm
Weight (lb/kg)0.6 lb / 0.27 Kg
ColorSilver
Sold byUnit
Return conditionsNo returnable if used. For more information about our return policy, please refer to the "Orders and Returns" link on the home page

Accessories

17 other products in the same category: