Cotton terry glove for women with an "Oil-bloc" nitrile lining ANSI heat resistance 3 THT™ design by Superior. Sold by the pair.

8 only in stock, discontinued product.

Cotton terry with Oil-bloc nitrile lining glove ANSI heat resistance 3. Sold by the pair. Model for women.

These gloves are available in two sizes: woman (7) or man (9) (see G203).

Superior manufacturer’s code: TRKONB

These cotton terry gloves are equipped with a nitrile lining which covers the whole surface of the palmar side of the glove. This layer basically covers the inside of the hand and is not design to withstand full submersion. Liquids are essentially absorbed from all over the glove, but when it comes to oils, the worker’s skin is only protected on the palmar side of the hand, not on the back of the hand.

These knitted gloves are designed accordingly to Superior’s ‘True Hand Technology’ or THT™. This design perfectly fits the hand, since it respects takes into account the human hand physiognomy, that is, the crotch between the little finger and the ring finger is located just a little lower than the other finger crotches.

These gloves are perfect to handle wet surfaces or oily parts. The terry knit fabric is quite absorbent, especially when it comes to oils and will offer a good dexterity.  This is why this glove is recommended for workers of the metalworking industry and those dealing with oily parts handling.

This glove is also approved level 3 accordingly to the ANSI standard heat resistance. Heat protection up to 392 F (200 C).

Maintenance and life service:
It is recommended to carry out a basic maintenance to extend the service life of your gloves. Simply wash them with hot water, that is, 105°F/40°C and a regular detergent. You can then dry them at medium temperature in a dryer. If needed, you may use bleach to remove the stains, but it is not required nor recommended to bleach your gloves every time you wash them.