FPH2000AE

Peakworks harness for controlled descent and confined groups A, P,L, E.

$98.75

safety harness. CSA groups A, P, L and E. With 6 D-rings: 1 back, 2 lateral for positioning, 2 on the shoulders for confined space rescue, and 1 frontal (sternal) for ladders and controlled descent. The chest and leg straps close with mating buckles.

Complies with CSA standard Z259.10-06.

Universal size. Ideal for ladder work, confined spaces, controlled descent, maintenance work, construction work, etc.

This harness is available in 1 universal size only.

The item number of this model corresponds to the universal size. To find out which size fits you best, please consult the manufacturer's sizing chart. Once you have identified your size, choose the appropriate product (see below, under the “Also available” tab, for other sizes).

This harness can support a maximum weight of 310 lb (140 kg), including clothing, tools, etc.

This lightweight North safety harness is made of woven non-stretch polyester. Polyester offers a superior resistance to acids. This harness model has crossover straps over the chest. For women, we recommend instead the North Rite-On or the Miss Miller harness models.

The chest straps and leg straps close with mating buckles. The harness certification tags are sewn on the front straps.

The worker is responsible for visually inspecting the harness before each use. During this routine inspection, the worker must note any signs of degradation, malfunction, or breakage. The harness will have to be replaced if any such signs are detected.

On top of this routine inspection, the harness must be inspected by a qualified person different than the worker that wears the harness. The frequency of these inspections varies according to the manufacturer. Some manufacturers require an inspection every 90 days, others every 180 days, or even yearly. These inspections should be performed more often if the harness is worn in extreme environmental working conditions.

The recommended lifetime of a safety harness if 5 years. While some manufacturers keep silent on this topic, in practice, if the harness is used regularly and stored and maintained in standard conditions, its lifetime will not exceed 5 years in most cases.

Sylprotec offers a safety harness inspection service. Find out more by clicking on the Services tab, under the Sylprotec logo at the top of the page.

Any equipment that has withstood a fall or an impact must be scrapped.

For cleaning, use a gentle soap or detergent and lukewarm water (37°C). Do not use bleach, chlorine, or other abrasive or chemical products. If your harness is too dirty or contaminated, it is time to replace it.

Air dry without using heat, in a clean environment. You can accelerate the drying process by wiping the wet harness with a clean absorbent wipe, or by using a fan. Avoid exposing the harness to sunlight and to any sources of contamination.

Reviews

No customer reviews for the moment.

Write a review
Peakworks harness for controlled descent and confined groups A, P,L, E.

Peakworks harness for controlled descent and confined groups A, P,L, E.

Accessories

17 other products in the same category: